Configure Stpd Forwarddelay - Extreme Networks ExtremeWare Command Reference Manual

STP Commands

configure stpd forwarddelay

configure stpd <spanning tree name> forwarddelay <seconds>
Description
Specifies the time (in seconds) that the ports in this STPD spend in the listening and learning states
when the switch is the Root Bridge.
Syntax Description
spanning tree name Specifies an STPD name on the switch.
seconds Specifies the forward delay time in seconds.
Default
15 seconds
Usage Guidelines
You should not configure any STP parameters unless you have considerable knowledge and experience
with STP. The default STP parameters are adequate for most networks.
The range for the
<seconds>
Example
The following command sets the forward delay from STPD1 to 20 seconds:
configure stpd stpd1 forwarddelay 20
History
This command was first available in ExtremeWare 2.0.
This command was added to the Summit "e" series of switches in ExtremeWare 6.2a and ExtremeWare
7.1e.
Platform Availability
This command is available on all platforms.
1442
parameter is 4 – 30 seconds.
ExtremeWare 7.5 Command Reference Guide