Configure Ports Egress-Rate-Limit - Extreme Networks ExtremeWare Command Reference Manual

High-Density Gigabit Ethernet Commands—Alpine 3800 and BlackDiamond 6800 Series Only

configure ports egress-rate-limit

configure ports <portlist> egress-rate-limit [percent <percent> | rate
<bps> [k | m]]
Description
Configures a maximum egress rate limit on the specified
Syntax Description
portlist Specifies one or more slots and ports. May be in the form 2:*, 2:5, 2:6-2:8.
percent Specifies the maximum percentage of bandwidth allowed for all egress traffic for each selected port.
The default is 100. The range is 0 to 100.
bps Specifies the maximum kilobits per second (kbps) or megabits per second (mbps) allowed for all
egress traffic for each selected port.
• k—kbps (the range is 0-1000000)
• m—mbps (the range is 0-1000)
Default
100 percent
Usage Guidelines
If you use the parameter to configure the egress rate limit, you must use an integer.
percent
The range is:
rate <bps>
• kbps—0 to 1000000
• mbps—0 to 1000
This setting is independent of any "i" series egress rate-limiting configurations that you have on the
switch and is applied to the aggregate bandwidth after the "i" series per-queue egress rate-limiting.
Example
The following command sets the maximum egress rate limit on slot 1, port 1 to 100 mbps:
configure ports 1:1 egress-rate-limit rate 100 m
History
This command was first available in ExtremeWare 7.1.
Platform Availability
This command is available on
2238
"3" series I/O modules only.
"3" series ports.
ExtremeWare 7.5 Command Reference Guide