Restart Multilink - Extreme Networks ExtremeWare Command Reference Manual

T1, E1, and T3 WAN Commands—Alpine 3800 Series Platforms

restart multilink

restart multilink <groupname>
Description
Restarts an MLPPP multilink group.
Syntax Description
groupname Specifies the multilink group name.
Default
N/A
Usage Guidelines
Use this command to restart a multilink group. This command is the equivalent of disabling and then
enabling a multilink group. You would use this command if you have changed any configuration
parameters of the MLPPP group. The changed configuration does not take effect until you disable then
enable the link, or until you restart the link.
Example
The following command restarts the multilink group ml_remote:
restart multilink ml_remote
History
This command was first available in ExtremeWare v6.1.5w2.01WAN technology release.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the Alpine 3800 series platform, when a WAN module is installed.
2214 ExtremeWare 7.5 Command Reference Guide