Enable Stpd - Extreme Networks ExtremeWare Command Reference Manual

STP Commands

enable stpd

enable stpd {<spanning tree name>}
Description
Enables the STP protocol for one or all STPDs.
Syntax Description
spanning tree name Specifies an STPD name on the switch.
Default
Disabled
Usage Guidelines
You must create one or more STP domains and configure an STPD before you can use the
enable stpd
command. Use the command to create an STPD.
create stpd
The keyword is optional. You do not need to indicate an STPD name if you
spanning tree name
enable the STP protocol for all STPDs.
To disable the STP protocol on a particular STPD or on all STPDs, use the command.
disable stpd
The default port mode is emistp, which requires an StpdID. When using 802.1d mode, configure the
mode of all the ports to dot1d before enabling the domain.
Example
The following command enables an STPD named Backbone_st:
enable stpd backbone_st
History
This command was first available in ExtremeWare 2.0.
This command was added to the Summit "e" series of switches in ExtremeWare 6.2a and ExtremeWare
7.1e.
Platform Availability
This command is available on all platforms.
1470 ExtremeWare 7.5 Command Reference Guide