Show Multilink E1 Errors - Extreme Networks ExtremeWare Command Reference Manual

T1, E1, and T3 WAN Commands—Alpine 3800 Series Platforms

show multilink e1 errors

show multilink <groupname> e1 errors near-end [totals | intervals |
current]
Description
Displays the current and past port error statistics for E1 multilink groups.
Syntax Description
groupname
Default
N/A
Usage Guidelines
For an E1 multilink group, you can display errors from the near-end only.
Display the total errors detected, errors detected per interval in the past, or errors detected in the
current interval.
For T1 multilink group errors, use the following command:
show multilink <groupname> t1 errors [near-end | far-end] [totals | intervals |
current]
Example
The following command displays the E1 multilink group errors detected on the near-end during the
current interval for the multilink group m_example1:
show multilink m_example1 e1 errors near-end current
History
This command was first available in ExtremeWare v6.1.8w3.0.1b56 WAN technology release.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the Alpine 3800 series platform, when a WAN module is installed.
2218
Specifies a previously created multilink group.
ExtremeWare 7.5 Command Reference Guide