Configure Wireless Ports Interface Ap-Scan Send-Probe - Extreme Networks ExtremeWare Command Reference Manual

Wireless Commands

configure wireless ports interface ap-scan send-probe

configure wireless ports [<portlist> | all] interface [1 | 2] ap-scan
send-probe <on |
off>
Description
Use this command to enable the sending of probes for active scanning.
Syntax Description
portlist
all
interface
on
off
Default
Off.
Usage Guidelines
Use this command to enable the sending of probes. Setting
Setting to
send-probe off
Example
The following example enables the port range 1:15-1:24 using interface 1 to enable probes.
configure wireless ports 1:15-1:24 interface 1 ap-scan send-probe on
History
This command was first available in ExtremeWare 6.2a and added to the "e" series in 7.3e.
Platform Availability
This command is available on the Summit 300-48, Summit 300-24, Summit 400-24p and Alpine switches.
1280
Specifies one or more ports or slots and ports. an be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
Specifies all ports.
Specifies an interface: 1 or 2.
Specifies to send probes (active scanning).
Specifies not to send probes (passive scanning).
specifies passive scanning.
to specifies active scanning.
send-probe on
ExtremeWare 7.5 Command Reference Guide