Configure Wireless Ports Interface Transmit-Power - Extreme Networks ExtremeWare Command Reference Manual

configure wireless ports interface transmit-power

configure wireless ports <portlist> interface [1 | 2] transmit-power
<level>
Description
Configures the power-level for the specified interface.
Syntax Description
portlist
interface
level
Default
Full
Usage Guidelines
Each wireless port on the Summit 300 contains two interfaces. Interface 1 supports 802.11a, and interface
2 supports 802.11b/g radio signals. The
command allows you to configure one of the two individual interfaces (1|2) on a port or ports. If there
is radio interference from other devices, then you can adjust the power level to an appropriate level
below full power.
Example
The following command configures the power level to half-power for interface 1 on ports 5 to 16 on a
Summit 300-24:
configure wireless port 5-16 interface 1 transmit-power half
History
This command was first available in ExtremeWare 6.2a and added to the "e" series in 7.3e. In 7.4, the
command syntax was changed from c
configure wireless ports interface transmit-power
Platform Availability
This command is available on the Summit 300-48, Summit 300-24, Summit 400-24p, and Alpine
switches.
ExtremeWare 7.5 Command Reference Guide
Specifies one or more ports or slots and ports. an be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
Specifies an interface: 1 or 2.
Specifies the power level for the interface. Valid values are:
• Full
• Half
• Quarter
• One-eighth
• Min (minimum)
configure wireless port interface transmit-power
onfigure wireless ports interface power-leve
configure wireless ports interface transmit-power
.
l to
1293