Displaying Ssh Status - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x System Basics Configuration Guide

Displaying SSH Status

You can monitor the current state of the SSH server with the show ip ssh command.
show ip ssh
444
Secure System Administration with SSH
Example
host1(config)#crypto key zeroize dss
There is no no version.
See crypto key dss.
Use to display the current state of the SSH server.
Use the detail keyword to display the encryption and MAC algorithm lists for
the client and server. For each active session, detail shows the version of SSH
running on the client and the algorithms in use for encryption and message
authentication.
Field descriptions
daemon status Indicates whether the SSH server is enabled; if so, how long
it has been up
supported encryption, inbound Encryption algorithms supported inbound
from the client
supported encryption, outbound Encryption algorithms supported outbound
to the client
supported MAC, inbound Message authentication code algorithms supported
inbound from the client
supported MAC outbound Message authentication code algorithms
supported outbound to the client
connections since last system reset Number of connections made through
SSH since the last time the system was reset
connections since daemon startup Number of connections made since the
SSH server was enabled
active sessions Number of SSH sessions currently active
id Session ID number
username Username for the remote user that initiated the session
host IP address of the remote client
uptime (d:h:m:s) Duration of the session
client version Version of the SSH software run by the remote client