Monitoring Flash Cards - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Monitoring Flash Cards

Use the show nvs command to monitor the status of NVS on the primary SRP module.
Use the show flash command to view information about the flash card.
show flash
show nvs
Root Directory OK
Checking File Space
Please Wait...
Checking Free Space
Please Wait...
PCMCIA Card Scan successful!
There is no no version.
See flash-disk scan.
Use to display information about the flash card.
Field descriptions
Active System Controller Information for flash cards on the active SRP
module
disk0 Flash card installed in slot 0 of the SRP module
disk1 Flash card installed in slot 1 of the SRP module; available only on
SRP modules for the E120 and E320 routers
Manufacturer Name of manufacturer of the installed flash card
Capacity Total capacity of the flash card, in bytes
Standby System Controller Information for flash cards on the standby SRP
module
Example
host1#show flash
Active System Controller:
-------------------------
Device Manufacturer
------ --------------
disk0 SILICONSYSTEMS
disk1 STI
Standby System Controller:
--------------------------
Device Manufacturer
------------- --------------
standby-disk0 SILICONSYSTEMS
standby-disk1 SILICONSYSTEMS
See show flash.
Chapter 6: Managing Modules
Capacity Status
---------- -------
1047126528 mounted
1024966656 mounted
Capacity Status
---------- -------
1047674880 mounted
1047674880 mounted
Managing Flash Cards on SRP Modules
391