JUNOSe 11.1.x System Basics Configuration Guide
Setting the Console Speed
You can specify the console speed for only the current console session or for the
current console session and all subsequent console sessions.
speed
terminal speed
Configuring the Display Terminal
You can specify the number of lines that appear on a terminal screen and the number
of characters that appear on a line.
terminal length
terminal width
282
Customizing the User Interface
Use to set the speed for the current and all subsequent console sessions
immediately.
Example
host1(config)#line console 0
host1(config-line)#speed 14400
Use the no version to revert to the default, 9600 bps.
See speed.
Use to set the speed for the current console session.
Example
host1#terminal speed 14400
There is no no version.
See terminal speed.
Use to set the number of lines on a screen.
If a command generates more lines than the number configured, the output
pauses after each screen.
Set the number of lines on a screen in the range 0–512.
Use 0 for no pausing.
Example
host1#terminal length 25
There is no no version.
See terminal length.