Example: Assigning Tcp/Ip Settings For Hosts Using Dhcp (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SCREENOS DEVICES GUIDE REV 01 Manual

Configuring ScreenOS Devices Guide
Related
Documentation

Example: Assigning TCP/IP Settings for Hosts Using DHCP (NSM Procedure)

58
features, a server preference, a DHCPv6 server, a DHCPv6 client, and a DHCPv6 relay
agent
Configuring Custom DHCP Options (NSM Procedure) on page 59
Using Interface Protocol on page 61
The Dynamic Host Configuration Protocol (DHCP) automatically assigns TCP/IP settings
for the hosts on the network. Different security devices support different DHCP roles:
DHCP clients receive a dynamically assigned IP address.
DHCP servers allocate dynamic IP addresses to clients.
DHCP relay agents receive information from a DHCP server and relay that information
to clients.
Some devices can simultaneously act as a DHCP client, server, and relay agent.
To assign TCP/IP settings to hosts using DHCP:
In the NSM navigation tree, select Device Manager > Devices.
1.
Select a security device and then double-click the device on which you want to define
2.
forced timeout. The device configuration appears.
In the device navigation tree, select Network > Interface.
3.
Double-click a trust interface. The General Properties screen appears.
4.
Select DHCP in the navigation tree, and for the DHCP Mode, select Server.
5.
Configure the server settings as follows:
6.
For DHCP Server Auto Processing, select Enable DHCP Server.
For DNS #1, #2, and #3, enter 1.1.1.1.
For Domain Name, enter acme.com.
For Client Gateway, enter 1.1.1.1.
For Lease Time (Minutes), the default is 4320 minutes.
For Netmask, the default is 0.
For NetInfo Server #1 and Server #2, enter 1.1.1.1.
For POP3, enter 1.1.1.1.
For SMTP, enter 1.1.1.1.
For WINS#1 and WINS#2, enter 1.1.1.1.
Select Enable Next Server IP.
Click OK to apply the settings.
Copyright © 2010, Juniper Networks, Inc.