Radius Configuration Mode; Radius Relay Configuration Mode - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

From Global Configuration mode, type the queue-profile command followed by a
queueProfileName, and press Enter.
host1(config)#queue-profile testabcd1234
host1(config-queue)#?

RADIUS Configuration Mode

In this mode, you can configure various parameters of your RADIUS authentication,
accounting, and dynamic-request servers.
From Global Configuration mode, type either the radius authentication server,
radius accounting server, or radius dynamic-request server command with the
server ipAddress, and press Enter.
host1(config)#radius authentication server 1.2.1.3
host1(config-radius)#?
deadtime Configure the amount of time a timed-out server is dropped for usage
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
key Configure the secret used in RADIUS client to server exchange
log Configure logging settings
macro Run a CLI macro
max-sessions Configure the number of outstanding requests allowed to the server
no Negate a command or set its default(s)
retransmit Configure the number of times to retransmit RADIUS request
before failing
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
timeout Configure the number of seconds to wait for a RADIUS response
before retransmitting
udp-port Configure the RADIUS server's UDP port

RADIUS Relay Configuration Mode

In this mode, you can configure various parameters of your RADIUS relay
authentication and accounting servers.
buffer-weight Set drop threshold in proportion to this weight
committed-length Set min and max constraints for committed threshold
conformed-fraction Set conformed threshold as a percentage of committed
conformed-length Set min and max constraints for conformed threshold
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exceeded-fraction Set exceeded threshold as a percentage of committed
exceeded-length Set min and max constraints for exceeded threshold
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
Chapter 2: Command-Line Interface
Accessing Command Modes
113