Table of Contents
Advertisement
JUNOSe 11.1.x System Basics Configuration Guide
Domain Map Tunnel Configuration Mode
In this mode, you can configure tunnel parameters such as the tunnel's endpoint.
From Domain-Map Configuration mode, type tunnel and a tunnelNumber, and press
Enter.
host1(config-domain-map)#tunnel 17
host1(config-domain-map-tunnel)#?
DoS Protection Group Configuration Mode
In this mode, you can configure parameters for Denial of Service (DoS) protection
groups.
From Global Configuration mode, type the dos-protection-group command and
press Enter.
host1(config)#dos-protection-group
host1(config-dos-protection)#?
94
Accessing Command Modes
no
Negate a command or set its default(s)
override-user
Configure the username and password values to use instead
of the values from the remote client
padn
Configure pppoe active discovery network parameters for
the domain name
router-name
Configure the virtual-router for the domain name
run
Run an exec mode command (alias command do)
sleep
Make the Command Interface pause for a specified duration
strip-domain
Configure the domain name stripping feature for the domain
tunnel
Configure tunnel tag
virtual-router
Configure the virtual-router for the domain name
address
Configure tunnel endpoint address
client-name Configure the client hostname of the tunnel
default
Set a command to its default(s)
exit
Exit from the current command mode
do
Run an exec mode command (alias command run)
help
Describe the interactive help system
hostname
Configure the client hostname of the tunnel
identification
Configure tunnel identification
log
Configure logging settings
macro
Run a CLI macro
max-sessions
Configure maximum sessions for this tunnel
medium
Configure tunnel medium
no
Negate a command or set its default(s)
password
Configure tunnel password
preference
Configure tunnel preference
run
Run an exec mode command (alias command do)
server-name
Configure the remote hostname for the tunnel
sleep
Make the Command Interface pause for a specified duration
source-address
Configure tunnel source address
type
Configure tunnel type
default
Set a command to its default(s)
do
Run an exec mode command (alias command run)
exit
Exit from the current command mode
help
Describe the interactive help system
log
Configure logging settings
macro
Run a CLI macro
Advertisement
Table of Contents
Troubleshooting
