Table of Contents
Advertisement
Basic Setup
Setting the Printer's Date and Time
In order to ensure accurate build times, the printer's clock must be set correctly. If you find that
your printer's date and/or time are incorrect you can update them using GrabCAD Print. To do
so, navigate to
procedure for "Changing your printer's clock time".
Updating the Controller software Version
Update the Controller Software if necessary. See
Adjusting the Tip Wipe Height
If necessary, adjust the tip wipe height. See
http://help.grabcad.com/article/196-printer-firmware-management
© Copyright 2020 Stratasys. All rights reserved.
Setting the Printer's Date and Time
"Updating Controller Software" (page
"Tip Wipe Height Adjustment" (page
and follow the
146).
144).
Page 17
Advertisement
Table of Contents
