Setting A Password For The Vfd; Viewing Vfd Status - INVT Goodrive350-19 Series Operation Manual

Goodrive350-19 series VFD for crane
All digits are blinking.
Note: When setting the value, you can press

6.4.2 Setting a password for the VFD

The VFD provides the user password protection function. When you set P07.00 to a non-zero value,
the value is the user password. If password protection is enabled, "0.0.0.0.0" is displayed when you
press the PRG/ESC key again to enter the function code editing interface. You need to enter the
correct user password to enter the interface.
To disable the password protection function, you need only to set P07.00 to 0.
After you exit the function code editing interface, the password protection function is enabled within 1
minute. If password protection is enabled, "0.0.0.0.0" is displayed when you press the PRG/ESC key
again to enter the function code editing interface. You need to enter the correct user password to
enter the interface.
All digits are blinking.
The units place is blinking.
Note: When setting the value, you can press

6.4.3 Viewing VFD status

The VFD provides group P17 for status viewing. You can enter group P17 for viewing.
PRG DATA
ESC ENT
PRG PRG
ESC ESC
The units place is blinking.
The units place is blinking.
»
SHIFT
Figure 6-3 Modifying a parameter
PRG
ESC
PRG
ESC
The units place is blinking.
DATA
ENT
The units place is blinking. The units place is blinking.
Figure 6-4 Setting a password
The units place is blinking. The units place is blinking.
DATA
ENT
and + to modify the value.
The units place is blinking.
PRG
ESC
PRG
ESC
PRG
ESC
»
and +
SHIFT
-133-
Basic operation guidelines
PRG DATA
ESC ENT
DATA
ENT
to modify the value.