Setting A Password For The Vfd - INVT Goodrive10 Series Operation Manual

Goodrive10 Series Mini VFD
cannot be modified due to either of the following reasons:
1) It is read only. Read-only parameters include actual detection parameters and running
record parameters.
2) It cannot be modified in running state and can be modified only in stopped state.
Example: Change the value of P00.01 from 0 to 1.
All digits are
blinking
Note: When setting the value, you can press

4.3.2 Setting a password for the VFD

Goodrive10 series VFDs provide password protection function to users. Set P07.00 to gain
the password and the password protection becomes effective 1 minute later after retreating
from the function code editing state. Press PRG/ESC again to the function code editing
state, "0.0.0.0.0" will be displayed. Unless using the correct password, you cannot enter it.
To disable the password protection function, you need only to set P07.00 to 0.
PRG
ESC
PRG
ESC
The units place
is blinking
The units place is blinking
Figure 4-3 Modifying a parameter
All digits are blinking
The units place is blinking
Note: When setting the value, you can press
Figure 4-4 Setting a password
DATA
ENT
PRG
ESC
The units place
is blinking
DATA
ENT
and
SHIFT
PRG
ESC
PRG
ESC
The units place is blinking
DATA
ENT
The units place is blinking
and
SHIFT
-23-
The units place is
blinking
PRG DATA
ESC
ENT
+ modify the value.
The units place is blinking
PRG DATA
ENT
ESC
DATA
ENT
PRG
ESC
The units place is blinking
+ modify the value.
Keypad operation