P00 Group--Basic Functions - INVT Goodrive350-19 Series Operation Manual

Goodrive350-19 series VFD for crane
parameters. Incorrect parameter setting may cause operation exceptions or even damage to the
VFD.) If password protection is not in locked state, you can change the password any time. You
can set P07.00
power-on, parameters are prevented from being modified by using the user password function.
When you modify function parameters through serial communication, the user password
protection function is also applicable and compliant with the same rule.
P00 group––Basic functions
Function
Name
code
Speed control
P00.00
mode
Channel of
P00.01 running
commands
Communication
P00.02 mode of running
commands
Max. output
P00.03
frequency
Upper limit of
P00.04
running frequency
to 0 to cancel the user password. When
0: Sensorless vector control (SVC) mode 0
1: Sensorless vector control (SVC) mode 1
2: Space voltage vector control mode
3: Closed-loop vector control mode
Note: Before using a vector control mode (0,
1, or 3), enable the VFD to perform motor
parameter autotuning first.
0: Keypad
1: Terminal
2: Communication
0: Modbus
1: PROFIBUS/CANopen/DeviceNet
2: Ethernet
3: EtherCAT/Profinet
4: Programmable expansion card
5: Wireless communication card
6: 216 communication card
Note: The options 1, 2, 3, 4, 5, and 6 are
add-on functions and are available only
when corresponding expansion cards are
configured.
Used to set the max. output frequency of the
VFD. Pay attention to the function code because
it is the foundation of the frequency setting and
the speed of acceleration (ACC) and
deceleration (DEC).
Setting range: Max (P00.04, 10.00)–150.00Hz
The upper limit of the running frequency is the
upper limit of the output frequency of the VFD,
which is lower than or equal to the max. output
P07.00
Description
-206-
Function parameter list
is set to a non-zero value during
Default
2
0
0
50.00Hz
50.00Hz
Modify
◎
○
○
◎
◎