INVT Goodrive350-19 Series Operation Manual page 188

Goodrive350-19 series VFD for crane
P05.08 (input terminal polarity)
0
S1
1 -1
0
S2
1 -1
0
S3
1 -1
0
S4
1 -1
P05.00
(HDI input type)
0
HDIA
1 -1
0
0
1
HD1B
1 -1
This parameter is used to set the corresponding function of digital multi-function input terminals.
Note: Two different multifunction input terminals cannot be configured with a same function.
Setting Function
0 No function
1 Run forward
2 Run reversely
3 Three-wire running control
4 Jog forward
5 Jog reversely
6 Coast to stop
7 Fault reset
8 Pause running
9 External fault input
10 Increase frequency setting Used to change the frequency increase/decrease command
P05.09 (digital filter time)
P05.12
T delay
P05.14
T delay
P05.16
T delay
P05.18
T delay
P05.20
T delay
P05.22
T delay
The VFD does not act even if there is signal input. Set
unused terminals to "no function" to avoid misaction.
External terminals are used to control the forward/reverse
running of the VFD.
The terminal is used to determine the three-wire running
control of the VFD. For details, see description for P05.13.
For details about frequency of jogging running and
ACC/DEC time of jogging running, see the description for
P08.06, P08.07, and P08.08.
The VFD blocks output, and the stop process of motor is
uncontrolled by the VFD. This mode is applied in the
scenarios with large-inertia loads and without stop time
requirements.
Its definition is the same as P01.08, and it is mainly used in
remote control.
External fault reset function, same as the reset function of
the STOP/RST key on the keypad. You can use this
function to reset faults remotely.
The VFD decelerates to stop, however, all the run
parameters are in memory state, such as PLC parameter,
wobbling frequency, and PID parameter. After this signal
disappears, the VFD will revert to the state before stop.
When external fault signal is transmitted to the VFD, the
VFD releases fault alarm and stops.
-176-
Basic operation guidelines
Digital function selection
P05.13
P05.01
T delay
(Default value is 1)
P05.15
T delay P05.02
(Default value is 4)
P05.17
T delay P05.03
(Default value is 7)
P05.19
T delay P05.04
(Default value is 0)
P05.21
T delay P05.05
(Default value is 0)
P05.23
T delay P05.06
(Default value is 0)
Description
0
1
2
3
Run P17.11
Digital input
terminal state
4
Fault?
5
P07.39
Fault
Input terminal
state of present
. fault
.
.
.
29
30