Macro Parameters (P90.00=9) - INVT Goodrive350-19 Series Operation Manual

Goodrive350-19 series VFD for crane
voltage vector control mode. The two modes are different in the brake timing logic, and
therefore you need to adjust P01, P04, and P90 parameters accordingly.

5.7.3 Macro parameters (P90.00=9)

Function
code
P00.01
P00.03 Max. output frequency
P00.04
P00.06
P00.11
P00.12
P04.01 Torque boost of motor 1
Torque boost cut-off of
P04.02
Enabling I/F mode for AM
P04.40
P05.03
P05.04
P06.03
P10.04
P10.06
P10.08
P10.10
P10.12
P11.08
P11.11
P25.01
P25.02
P25.03
P25.04
Enabling brake-oriented
P90.04
P90.12 Forward brake release
Name
Channel of running
commands
Upper limit of running
frequency
Setting channel of A
frequency command
ACC time 1
DEC time 1
motor 1
1
Function of S3
Function of S4
RO1 output
Multi-step speed 1
Multi-step speed 2
Multi-step speed 3
Multi-step speed 4
Multi-step speed 5
VFD/motor OL/UL
pre-alarm selection
Underload pre-alarm
detection threshold
Function of S5
Function of S6
Function of S7
Function of S8
logic
Setting
1
100.00Hz
100.00Hz
6
8.0s
8.0s
0.1% Disable automatic torque boost.
0.1%
1
85
7
49
8.0%
20.0%
30.0%
40.0%
50.0%
Enable underload protection to
0x021
enhance equipment safety.
15%
75
16
17
18
1 The brake is controlled by the VFD.
50.0% Corresponding to the motor rated
-59-
Commissioning guidelines
Remarks
Terminal
Multi-step speed run
Enable the I/F mode.
Enable brake detection
Fault reset
Brake output
Brake feedback signal
Multi-step speed 1
Multi-step speed 2
Multi-step speed 3