ST STM32WL5 Series Reference Manual page 1025

RM0453
Bit 19 COSEL: Calibration output selection
Bit 18 BKP: Backup
Bit 17 SUB1H: Subtract 1 hour (winter time change)
Bit 16 ADD1H: Add 1 hour (summer time change)
Bit 15 TSIE: Timestamp interrupt enable
Bit 14 WUTIE: Wakeup timer interrupt enable
Bit 13 ALRBIE: Alarm B interrupt enable
Bit 12 ALRAIE: Alarm A interrupt enable
Bit 11 TSE: timestamp enable
Bit 10 WUTE: Wakeup timer enable
Bit 9 ALRBE: Alarm B enable
Bit 8 ALRAE: Alarm A enable
When COE = 1, this bit selects which signal is output on CALIB.
0: Calibration output is 512 Hz
1: Calibration output is 1 Hz
These frequencies are valid for RTCCLK at 32.768 kHz and prescalers at their default values
(PREDIV_A = 127 and PREDIV_S = 255). Refer to
This bit can be written by the user to memorize whether the daylight saving time change has
been performed or not.
When this bit is set outside initialization mode, 1 hour is subtracted to the calendar time if the
current hour is not 0. This bit is always read as 0.
Setting this bit has no effect when current hour is 0.
0: No effect
1: Subtracts 1 hour to the current time. This can be used for winter time change.
When this bit is set outside initialization mode, 1 hour is added to the calendar time. This bit
is always read as 0.
0: No effect
1: Adds 1 hour to the current time. This can be used for summer time change
0: Timestamp interrupt disable
1: Timestamp interrupt enable
0: Wakeup timer interrupt disabled
1: Wakeup timer interrupt enabled
0: Alarm B interrupt disable
1: Alarm B interrupt enable
0: Alarm A interrupt disabled
1: Alarm A interrupt enabled
0: timestamp disable
1: timestamp enable
0: Wakeup timer disabled
1: Wakeup timer enabled
0: Alarm B disabled
1: Alarm B enabled
0: Alarm A disabled
1: Alarm A enabled
RM0453 Rev 1
Real-time clock (RTC)
Section 32.3.16: Calibration clock output.
1025/1461
1057