Drawing Type Or Serial Number - Siemens TXP-CLC Manual

Drawing Type or Serial Number

The Drawing Type or Serial Number field defines the type of drawing. This is
sometimes a particular type of drawing identified by a letter. Or, in other cases a
serial number is assigned to the drawing. The drawing types used in the KKS
system are listed below. The drawing type can usually be found in the title block
for each drawing.
A Power section drives and power section controllers
B Control interface drives and control interface controllers
C Binary signal conditioning
D Analog signal conditioning
E Limit value formation
F Turbine protection
G Alarm annunciation system (individual diagrams)
H Equipment or special automatic control
L Subgroup control, control coordination section
M Subgroup control, startup program
N Subgroup control, shutdown program
P Subgroup control, step indication
Q Subgroup control, criteria indication
S Alarm annunciation system
X Power cable
Y Measuring and control cable > 60 V
Measuring and control cable ≤ 60 V
Z
1
The KKS system does not contain the drawing type F. The combustion turbine function charts do
however use drawing type F for the turbine protection. These drawings are found in the I&C manuals.
Copying of this document, and giving it to others and use or communication of the contents, are forbidden without express authority. Offenders are liable to the payment of
damages. All rights are reserved in the event of the grant of a patent or the registration of a utility model or design.
1
Training Center
TXP CLC Course
5
21