Reflector Cluster-Id; Route-Distinguisher - Huawei Quidway S8500 Series Command Manual

Command Manual – MPLS
Quidway S8500 Series Routing Switches
Example
# Disable the routing reflection from client to client.
[Quidway-bgp-af-vpn] undo reflect between-clients

2.1.61 reflector cluster-id

Syntax
reflector cluster-id { cluster-id | address }
undo reflect cluster-id
View
VPNv4 subaddress family view
Parameter
cluster-id: Router reflector cluster ID in number format, in the range of 1 to
4294967295.
address: Router reflector cluster ID in IP address format.
Description
Use the reflector cluster-id command to configure a cluster ID of router reflector.
Use the undo reflector cluster-id command to delete the configuration.
By default, each router reflector uses his own ID as a cluster ID.
Usually, one cluster has one router reflector. And it is the router ID of the reflector to
identify this cluster. Several router reflectors make the network more stable. If one
cluster has several router reflectors, set the same cluster to all the reflectors ID with this
command.
Related command: reflect between-clients and peer reflect-client.
Example
# The local router is one of the reflectors in the cluster and identifies this cluster with the
cluster ID.
[Quidway-bgp-af-vpn] reflect cluster-id 80
[Quidway-bgp-af-vpn] peer 11.128.160.10 reflect-client

2.1.62 route-distinguisher

Syntax
route-distinguisher route-distinguisher
Chapter 2 BGP/MPLS VPN Configuration Commands
Huawei Technologies Proprietary
2-50