Ntp-Service Unicast-Peer - Huawei Quidway S8500 Series Command Manual

Command Manual – System Management
Quidway S8500 Series Routing Switches
interface-number: Specifies the interface number and determine an interface with the
interface-type parameter.
Description
Use the ntp-service source-interface command to designate an interface to transmit
NTP message.
Use the undo ntp-service source-interface command to cancel the current setting.
By default, the source address specifies where the packets are transmitted from.
You can use this command to designate an interface to transmit all the NTP packets
and take the source address of these packets from its IP address. If you do not want
any other interface to receive the acknowledgement packets, use this command to
specify one interface to send all the NTP packets.
Example
# Configure all the outgoing NTP packets to use the IP address of Vlan-Interface1 as
their source IP address.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] ntp-service source-interface Vlan-Interface 1

7.1.16 ntp-service unicast-peer

Syntax
ntp-service unicast-peer ip-address [ version number ] [ authentication-key keyid ]
[ source-interface interface-type interface-number ] [ priority ]*
undo ntp-service unicast-peer ip-address
View
System view
Parameter
ip-address: Specifies the IP address of a remote server.
version: Defines NTP version number.
number: NTP version number, ranging from 1 to 3.
authentication-keyid: Defines authentication key.
keyid: Key ID used for transmitting messages to a remote server, ranging from 1 to
4294967295.
source-interface: Specifies the name of an interface, the interface can be VLAN
interface and Loopback interface currently.
Huawei Technologies Proprietary
7-13
Chapter 7 NTP Configuration Commands