Huawei Quidway S8500 Series Command Manual page 1149

Command Manual – System Management
Quidway S8500 Series Routing Switches
keyid: Key ID used for transmitting messages to a remote server, ranging from 1 to
4294967295.
source-interface: Specifies the name of an interface, the interface can be VLAN
interface and Loopback interface.
interface-type: Specifies the interface type and determine an interface together with the
interface-number parameter.
interface-number: Specifies the interface number and determine an interface together
with the interface-type parameter.
priority: Designates a server as the first choice.
Description
Use the ntp-service unicast-server command to configure NTP server mode.
Use the undo ntp-service unicast-server command to disable NTP server mode.
By default, version number number defaults to 3, the authentication is disabled, and the
local server is not the first choice.
The command announces to use the remote server at ip-address as the local time
server. ip-address specifies a host address other than an IP address of broadcast,
multicast, or reference clock. By operating in client mode, a local device can be
synchronized by a remote server, but not synchronize any remote server.
Example
# Designate the server at 128.108.22.44 to synchronize the local device and use NTP
version 3.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] ntp-service unicast-server 128.108.22.44 version 3
Huawei Technologies Proprietary
7-15
Chapter 7 NTP Configuration Commands