Huawei Quidway S8500 Series Command Manual page 292

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches
<Quidway>display ip routing-table 1.1.1.0 24 2.2.2.0 24
Routing tables:
Summary count: 3
Destination/Mask
1.1.1.0/24
1.1.1.1/32
2.2.2.0/24
For detailed description of the output information, see Table 1-1.
1.1.5 display ip routing-table ip-prefix
Syntax
display ip routing-table ip-prefix ip-prefix-name [ verbose ]
View
Any view
Parameter
ip-prefix-name: ip prefix list name.
verbose: With the parameter, this command displays the verbose information of both
the active and inactive routes that passed filtering rules. Without the parameter, this
command displays the summary of the active routes that passed filtering rules.
Description
Use the display ip routing-table ip-prefix command to view the route information that
passed the filtering rule according the input ip prefix list name.
This command is mainly used to trace the route-policy and display the corresponding
route information.
If there is no specified address prefix list, this command will display the verbose
information of all Active and Inactive routes with the verbose keyword and it will display
the summary of all Active routes without the verbose keyword.
Example
# Configure the ip prefix list abc2, allowing the routes with the prefix as 10.1.1.0 and a
mask length in the range 24 to 32 to pass.
[Quidway] ip ip-prefix abc2 permit 10.1.1.0 24 less-equal 32
<Quidway> dis ip routing-table protocol static
STATIC Routing tables:
Summary count: 3
STATIC Routing table status:<active>:
Summary count: 3
Chapter 1 Static Route Configuration Commands
Protocol Pre Cost
DIRECT 0 0
DIRECT 0 0
DIRECT 0 0
Huawei Technologies Proprietary
1-9
Nexthop Interface
1.1.1.1 Vlan-interface1
127.0.0.1 InLoopBack0
2.2.2.1 Vlan-interface2