Stop-Accounting-Buffer Enable; Timer Quiet - Huawei Quidway S8500 Series Command Manual

Command Manual – Security
Quidway S8500 Series Routing Switches

2.2.25 stop-accounting-buffer enable

Syntax
stop-accounting-buffer enable
undo stop-accounting-buffer enable
View
RADIUS scheme view
Parameter
None
Description
Use the stop-accounting-buffer enable command to configure to save the stopping
accounting requests without response in the switch system buffer.
Use the undo stop-accounting-buffer enable command to cancel the function of
saving the stopping accounting requests without response in the switch system buffer.
By default, enable to save the stopping accounting requests in the buffer.
Because the stopping accounting request concerns account balance and will affect the
amount of charge, which is very important for both the user and ISP, NAS shall make its
best effort to send the message to RADIUS accounting server. Accordingly, if the
message from the switch to RADIUS accounting server has not been responded, the
switch shall save it in the local buffer and retransmit it until the server responds or
discard the messages after transmitting for specified times.
Related command: reset stop-accounting-buffer, radius scheme, display
stop-accounting-buffer.
Example
# ,Enable the switch to buffer the stop-accounting requests that get no answer from the
server configured for the RADIUS scheme "huawei".
[Quidway-radius-huawei] stop-accounting-buffer enable

2.2.26 timer quiet

Syntax
timer quiet minutes
undo timer quiet
View
RADIUS scheme view
Chapter 2 AAA and RADIUS/HWTACACS Protocol
Huawei Technologies Proprietary
2-45
Configuration Commands