Mirroring-Group Reflector-Port; Mirroring-Group Remote-Probe Vlan - Huawei Quidway S3900 series Command Manual

Command Manual – Mirroring
Quidway S3900 Series Ethernet Switches-Release 1510
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] mirroring-group 1 monitor-port Gigabitethernet1/1/4

1.1.7 mirroring-group reflector-port

Syntax
mirroring-group group-id reflector-port reflector-port
undo mirroring-group group-id reflector-port reflector-port
View
System view/Ethernet port view
Parameter
group-id: Group number of a port mirroring group, in the range of 1 to 20.
reflector-port reflector-port: Specifies the reflector port. reflector-port is available in
system view only, but not in Ethernet port view.
Description
Use the mirroring-group reflector-port command to specify the reflector port.
Use the undo mirroring-group reflector-port command to remove the configuration
of the reflector port..
Note the following when you configure the reflector port:
The reflector port must be an Access port.
LACP and TCP must be disabled on the reflector port.
After a port is configured as a reflector port, the switch does not allow you to
change the port type and its default VLAN ID, or to add it to another VLAN.
To mirror tagged packets, you need to configure VLAN VPN on the reflector port.
Example
# Configure GigabitEthernet1/1/2 as the reflector port.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] mirroring-group 1 reflector-port GigabitEthernet1/1/2

1.1.8 mirroring-group remote-probe vlan

Syntax
mirroring-group group-id remote-probe vlan remote-probe-vlan-id
Huawei Technologies Proprietary
1-7
Chapter 1 Mirroring Commands