Huawei Quidway S8500 Series Command Manual page 1259

Command Manual – Integrated Management
Quidway S8500 Series Routing Switches
Parameter
lanswitch-loclist: List of position parameters of the Ethernet switches to be configured.
An Ethernet switch position parameter is a string that comprises slot number, subslot
number, port number, and sequence number.
name-list: List of Aliases to be set for the Ethernet switches.
Description
Use the set lswname command to configure aliases for specified Ethernet switches.
Use the undo set lswname command to remove the aliases of specified Ethernet
switches.
HGMP identifies each Ethernet switch by the corresponding position parameter.
However, it is infeasible for users to locate a managed Ethernet switch in time using its
position parameters. An alternative is to assign aliases to Ethernet switches. Note that
the position parameters specified by the lanswitch-loclist argument and the aliases
specified by the name-list argument are one-to-one mapped.
Example
# Assign alias of "1#S3526" to the Ethernet switch with a position parameter of 0/1/6-/.
[Quidway-hgmp] set lswname 0/1/6-/ 1#S3526
Config lanswtich name successfully,please run backup lswconfig for save
configuration to flash!
1.1.18 spanning-hub
Syntax
spanning-hub { enable | disable } slotno subslot port-list
View
HGMP view
Parameter
enable: Specifies the network connected to the port to be of star topology.
disable: Specifies the network connected to the port not to be of star topology..
slotno: Slot number.
subslot: Subslot number.
port-list: Port list.
Description
Use the spanning-hub command to specify the network connected to the specified
port of the management device to be of star topology.
Chapter 1 HGMP V1 Configuration Commands
Huawei Technologies Proprietary
1-19