Stp Port Priority - Huawei Quidway S8500 Series Command Manual

Command Manual – STP
Quidway S8500 Series Routing Switches
Description
Use the stp point-to-point command to configure the current Ethernet port (not) to
connect with point-to-point link.
Use undo stp point-to-point command to configure the link state to the default state in
which MSTP automatically detects if the link to the Ethernet port is point-to-point link.
By default, switch adopts auto mode.
The port not connected with the point-to-point link cannot transit fast.
The master ports of the link aggregation and the ports operating in full-duplex mode are
connected to the point-to-point link. You are recommended to keep the default settings
and let MSTP detect the link state automatically.
This configuration takes effect on the CIST and all the MSTIs. The settings of a port
whether to connect the point-to-point link will be applied to all the MSTIs where the port
belongs. Note that a temporary loop may be redistributed if you configure a port not
physically connected with the point-to-point link as connected to such a link by force.
Related command: stp interface point-to-point.
Example
# Configure Ethernet2/1/3 to be connected to the point-to-point link.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface Ethernet2/1/3
[Quidway-Ethernet2/1/3] stp point-to-point force-true

1.1.33 stp port priority

Syntax
stp [ instance instance-id ] port priority priority
undo stp [ instance instance-id ] port priority
View
Ethernet port view
Parameter
instance instance-id: Specifies the spanning tree instance ID, ranging from 0 to 48.
The Instance 0 represents CIST.
port priority priority: Specifies the port priority, ranging from 0 to 240, with a step length
of 16, e.g., 0, 16, and 32. By default, the priorities of a port on the MSTIs are 128.
Huawei Technologies Proprietary
1-34
Chapter 1 MSTP Configuration Commands