Peer - Huawei Quidway S8500 Series Command Manual

Command Manual – NAT&URPF&VPLS
Quidway S8500 Series Routing Switches
Example
# Set the MTU value for the VPLS instance Huawei to 1,400 bytes.
[Quidway-vsi-Huawei-ldp] mtu 1400

3.1.12 peer

Syntax
peer peer-ip [ vc-id vc-id ] [ upe ] [ { backup-peer | primary-peer } alternatepeer-ip ]
[ trans-mode { raw | tagged } ]
undo peer peer-ip
View
VSI-LDP View
Parameter
peer-ip: IP address of a VPLS remote peer PE.
vc-id: ID of the VC to the VLPS peer PE. It defaults to VSI-ID.
upe: Specifies that the type of the VPLS peer is UPE, that is, the peer is a user
convergence node UPE in hierarchical VPLS architecture.
trans-mode: Specifies the VC encapsulation mode.
raw: Specifies that the VC encapsulation mode is Ethernet Raw.
tagged: Specifies that the VC encapsulation mode is Ethernet Tagged.
backup-peer: Specifies the IP address of the backup PE corresponding to the primary
PE of the UPE.
primary-peer: Specifies the IP address of the primary PE corresponding to the backup
PE of the UPE.
alternatepeer-ip: Specifies the IP address of the corresponding backup peer PE in
hierarchical VPLS architecture as the IP address of the VPLS peer.
Description
Use the peer command to create a VPLS peer PE contained in an instance. When you
create a VPLS peer PE, you must specify an IP address and peer type for the peer PE.
Use the undo peer command to remove the specified VPLS peer PE.
By default, the peer type is NPE. When you specify UPE as the peer type, it indicates
the peer is a user convergence node UPE in hierarchical VPLS architecture. You can
also specify an ID for a VC to the peer, and the ID must be consistent with that of the
remote. Multipoint-to-multipoint connections are needed among specified multiple
remote peer NPEs, but not needed between UPEs and NPEs.
By default, VC-ID is VSI-ID.
Huawei Technologies Proprietary
3-10
Chapter 3 VPLS Configuration Commands