Huawei Quidway S8500 Series Command Manual page 927

Command Manual – Security
Quidway S8500 Series Routing Switches
Description
Use the retry stop-accounting command to configure the maximal retransmission
times after a stop-accounting request is saved into the buffer due to getting no
response.
Use the undo retry stop-accounting command to restore the retransmission times to
the default value.
Because the stopping accounting request concerns account balance and will affect the
amount of charge, which is very important for both the user and ISP, NAS shall make its
best effort to send the message to RADIUS accounting server. Accordingly, if the
message from the switch to RADIUS accounting server has not been responded, the
switch shall save it in the local buffer and retransmit it until the server responds or
discard the messages after transmitting for specified times.
Related command: reset stop-accounting-buffer, radius scheme, display
stop-accounting-buffer.
Example
#Perform the following configuration such that the switch can retransmit a buffered
stop-accounting request to the server configured for the RADIUS scheme "Huawei" for
up to 1000 times
[Quidway-radius-huawei] retry stop-accounting 1000
2.2.21 secondary accounting
Syntax
secondary accounting ip-address [ port-number ]
undo secondary accounting
View
RADIUS scheme view
Parameter
ip-address: IP address, in dotted decimal format. By default, the IP addresses of
secondary accounting server is at 0.0.0.0.
port-number: Specifies the UDP port number, ranging from 1 to 65535. By default, the
accounting service is provided via UDP 1813.
Description
Use the secondary accounting command to configure the IP address and port
number for the secondary RADIUS accounting server.
Chapter 2 AAA and RADIUS/HWTACACS Protocol
Huawei Technologies Proprietary
2-41
Configuration Commands