Huawei Quidway S8500 Series Command Manual page 319

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches
Example
# Disable the interface Vlan-interface 10 to run the RIP.
[Quidway] interface Vlan-interface 10
[Quidway-Vlan-interface10] undo rip work
2.1.21 summary
Syntax
summary
undo summary
View
RIP view
Parameter
None
Description
Use the summary command to configure to activate RIP-2 automatic route
summarization.
Use the undo summary command to disable RIP-2 automatic route summarization.
By default, RIP-2 route summarization is used.
Automatic route summarization can be performed to reduce the routing traffic on the
network as well as to reduce the size of the routing table. If RIP-2 is used, route
summarization function can be disabled with the undo summary command, when it is
necessary to broadcast the subnet route.
RIP-1 does not support subnet mask. Forwarding subnet route may cause ambiguity.
Therefore, RIP-1 uses route summarization all the time. Thus, the undo summary
command does not take effect on RIP-1.
Related command: rip version.
Example
# Set RIP version on the interface Vlan-interface 10 to RIP-2 and disable the route
summarization function.
[Quidway] interface Vlan-interface 10
[Quidway-Vlan-interface10] rip version 2
[Quidway-Vlan-interface10] quit
[Quidway] rip
[Quidway-rip] undo summary
Huawei Technologies Proprietary
2-17
Chapter 2 RIP Configuration Commands