Kompella Mpls L2Vpn Configuration Commands - Huawei Quidway S8500 Series Command Manual

Command Manual – MPLS
Quidway S8500 Series Routing Switches
Example
# Create a virtual connection with the ID of 23.
[Quidway-Vlan-interface201] mpls l2vc 10.0.0.11 23

3.3 Kompella MPLS L2VPN Configuration Commands

3.3.1 ce
Syntax
ce name [ id id [ range range | default-offset offset ]
undo ce name
View
MPLS L2VPN view
Parameter
name: Name of the CE, which must be unique in the current VPN of the PE. This
argument is 1 to 20 characters in length.
id: CE ID, which is used to uniquely identify a CE in the VPN. This argument ranges
from 0 to 499.
offset: Specifies the default original CE offset.
range: CE Range, the maximum number of CEs that can be connected to the CE. This
argument ranges from 1 to 500.
Description
Use the ce command to create a CE or modify the CE Range.
Use the undo ce command to remove a CE.
The corresponding CE view is created when you create a CE. All the CE connections
are configured in CE view.
For VPN capacity expansion, you can set the range argument to a value lager than the
currently required number of CEs to be connected. However, this may result in the
waste of tags as the system allocates tag blocks for CEs according to the value of the
range argument. You can also change the CE Range to a larger number when
expanding the VPN (if the previously set CE range is not large enough). For example, if
the desired CE number is 20 after the expansion, but the current CE Range is 10, you
can change the CE range to 20.
Related command: mpls l2vpn encapsulation, ccc.
Chapter 3 MPLS L2VPN Configuration Commands
Huawei Technologies Proprietary
3-10