Schedule Reboot Delay - Huawei Quidway S8500 Series Command Manual

Command Manual – System Management
Quidway S8500 Series Routing Switches
Note:
The precision of switch timer is 1 minute. The switch will reboot in one minute when
time comes to the specified rebooting point.
If the schedule reboot at command sets specified date parameters, which represents
a data in the future, the switch will be restarted in specified time, with error not more
than 1 minute.
If no specified date parameters are configured, two cases are involved: If the
configured time is after the current time, the switch will be restarted at the time point of
that day; if the configured time is before the current time, the switch will be restarted at
the time point of the next day.
It should be noted that the configured date should not exceed the current date more
than 30 days. In addition, after the command is configured, the system will prompt you
to input confirmation information. Only after the "Y" or the "y" is entered can the
configuration be valid. If there is related configuration before, it will be covered directly.
Moreover, after the schedule reboot at command is configured and the system time is
adjusted by the clock command, the former configured schedule reboot at parameter
will go invalid.
Related command: reboot, display schedule reboot.
Example
# Set the switch to be restarted at 22:00 that night (the current time is 15:50).
<Quidway> schedule reboot at 22:00
Reboot system at 22:00:00 UTC 2003/11/18 (in 6 hours and 10 minutes)
confirm?[Y/N]:y
aux0: schedule reboot parameters at 15:50:00 UTC 2003/11/18. And system will
reboot at 22:00:00 UTC 2003/11/18
Proceed with reboot? [Y/N]:y

3.1.13 schedule reboot delay

Syntax
schedule reboot delay { hhh:mm | mmm }
undo schedule reboot
View
User view
Huawei Technologies Proprietary
3-9
Chapter 3 Device Management Commands