Dot1X Guest-Vlan - Huawei Quidway S8500 Series Command Manual

Routing switches
Hide thumbs Also See for Quidway S8500 Series:
Table of Contents

Advertisement

Command Manual – Security
Quidway S8500 Series Routing Switches
Use the undo dot1x dhcp-launch command to set 802.1x to enable the switch to
trigger the authentication over them.
By default, the switch can trigger the user ID authentication over the users who
configure static IP addresses in DHCP environment.
Related command: dot1x.
Example
# Disable the switch to trigger the authentication over the users who configure static IP
addresses in DHCP environment.
[Quidway] dot1x dhcp-launch

1.1.6 dot1x guest-vlan

Syntax
dot1x guest-vlan vlan-id [ interface interface-list ]
undo dot1x guest-vlan vlan-id [ interface interface-list ]
View
System view, Ethernet interface view
Parameter
vlan-id: ID of the VLAN specified as the Guest VLAN. It ranges from 1 to 4094.
interface-list: List of Guest VLAN-enabled ports expressed in the format interface-list
=interface-type interface-number [ to interface-type interface-number ] &<1-10>.
interface-type means the interface type, interface-number is the interface number.
Refer to command parameters in the "Port" section in the manual for the respective
meanings and value ranges of them. The interface number after the key word to should
be no smaller than the interface number before to. &<1-10> in the command means
that the preceding parameter can be entered up to 10 times.
Description
Use the dot1x guest-vlan command to enable Guest VLAN on a specific port.
Use the undo dot1x guest-vlan command to disable Guest VLAN.
If you execute the dot1x guest-vlan command in system view and do not provide the
interface-list argument, Guest VLAN is enabled on all ports. However, if you provide the
interface-list argument, Guest VLAN is enabled on the ports specified by this argument.
If you execute the dot1x guest-vlan command in Ethernet interface view, this
command does not accept the interface-list argument and Guest VLAN is enabled only
on the current port.
Huawei Technologies Proprietary
1-7
Chapter 1 802.1x Configuration Commands

Advertisement

Table of Contents
loading

Table of Contents