Lanswitch - Huawei Quidway S8500 Series Command Manual

Command Manual – Integrated Management
Quidway S8500 Series Routing Switches
Parameter
enable: Specifies to enable HGMP Server.
disable: Specifies to disable HGMP Server.
Description
Use the hgmpserver command to enable/disable HGMP Server.
Use the undo hgmpserver command to restore the default HGMP Server
configuration.
By default, the HGMP Server is disabled on a switch.
After HGMP Server is enabled normally, the system enters HGMP view. The hgmp
server command can only be executed in HGMP view or lanswitch view.
Example
# Enable HGMP Server on an Ethernet switch.
[Quidway] hgmpserver enable
Start HGMP protocol successfully!

1.1.8 lanswitch

Syntax
lanswitch { lanswitch-loc }
View
HGMP view
Parameter
lanswitch-loc: Ethernet switch position parameter, a string that comprises slot number,
subslot number, port number and sequence number. This argument does not indicate
the actual physical position.
Description
Use the lanswitch command to enter lanswitch view.
You can configure an Ethernet switch after you enter the corresponding lanswitch view.
To enter the lanswitch view of a specified switch through the management device, you
must have the switch register successfully with the management device and operate
properly. The management device automatically retrieves the position parameters of
Ethernet switches. You can obtain the position parameter of an Ethernet switch by
using the display lanswitch command.
Related command: display lanswitch.
Chapter 1 HGMP V1 Configuration Commands
Huawei Technologies Proprietary
1-9