Stp Interface Instance Port Priority - Huawei Quidway S8500 Series Command Manual

Command Manual – STP
Quidway S8500 Series Routing Switches
Use the stp interface edged-port disable command to configure a port as a non-edge
port in system view.
Use the undo stp interface edged-port command to restore the port to the default
type (that is, non-edge port) in system view.
By default, all the switch ports are configured as non-edge ports.
If the current Ethernet port is connected to other switches, you can use the stp
interface edged-port disable or undo stp interface edged-port command to
configure it as a non-edge port. The stp interface edged-port enable command is
used for configuring the port as an edge port.
A port is considered as an edge port when it is directly connected to the user terminal,
instead of any other switches or shared network segments. The edge port will not
cause loop upon network topology changes. Accordingly, you can configure a port as
an edge port, so that it can transit to forwarding state fast. For this purpose, configure
the Ethernet port directly connected to the user terminal as an edge port.
Because the edge port is not connected to any other switches, it will not receive the
configuration BPDUs from them.
Related command: stp edged-port.
Example
# Configure Ethernet2/1/3 as an edge port in system view.
<Quidway>system-view
System View: return to User View with Ctrl+Z
[Quidway] stp interface Ethernet 2/1/3 edged-port enable

1.1.20 stp interface instance port priority

Syntax
stp interface interface-list instance instance-id port priority priority
undo stp interface interface-list instance instance-id port priority
View
System view
Parameter
interface-list: Ethernet port list, containing multiple Ethernet ports and expressed as
interface-list
interface-number ] }&<1-10>. For detail descriptions of interface-type and
interface-number parameters, refer to the corresponding descriptions in Port
Command Manual. &<1-10> means that the preceding parameters can be entered up
to 10 times
= { interface-type
Huawei Technologies Proprietary
1-21
Chapter 1 MSTP Configuration Commands
interface-number [ to interface-type