Huawei Quidway S8500 Series Command Manual page 956

Command Manual – Reliability
Quidway S8500 Series Routing Switches
virtual-router-ID: VRRP virtual router ID, ranging from 1 to 255.
Description
Use the display vrrp command to view the information about the VRRP state.
If the interface name and virtual router ID are not specified, the state information about
all the virtual routers on the switch will be displayed. If only the interface name is
specified, the state information about all the virtual routers on the interface will be
displayed. If the interface name and virtual router ID are specified, the state information
about the specified virtual router on the interface will be displayed.
Example
# Display the VRRP state information on VLAN-interface 1.
[Quidway-Vlan-interface1] display vrrp interface vlan-interface 1
Run Method : VIRTUAL-MAC
Virtual Ip Ping : Disable
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Track IF
Virtual IP
Master IP
Table 1-1 Description on the fields of the display vrrp command
Run Method
Virtual IP ping
Interface
VRID
Adver.Timer
Admin Status
State
Config Pri
Run Pri
Preempt Mode
Delay Time
: Vlan-interface1
: 1
: UP
: 100
: YES
: NONE
: Vlan-interface2
: 1.1.1.1
: 0.0.0.0
Field
Run method: real or virtual MAC method
Whether to enable to ping through virtual IP
Interface in which virtual router resides
ID of virtual router
Interval for sending vrrp packets
Control status of virtual router
Running state of virtual router
Configured priority
Run priority
Preempt mode
Delay time
Huawei Technologies Proprietary
Chapter 1 VRRP Configuration Commands
Adver. Timer
State
Run Pri
Delay Time
Pri Reduced
Description
1-2
: 1
: Initialize
: 90
: 0
: 10