Stp Pathcost-Standard; Stp Point-To-Point - Huawei Quidway S8500 Series Command Manual

Command Manual – STP
Quidway S8500 Series Routing Switches

1.1.31 stp pathcost-standard

Syntax
stp pathcost-standard { dot1t | dot1d-1998 | legacy }
View
System view
Parameter
dot1t, dot1d-1998, legacy : Three standards of the path cost calculation on STP port.
Description
Use the stp pathcost-standard command to set the path cost calculation standard on
STP port.
The port rate must be obtained first before you can calculate the path cost of a port as
the path cost is associated with the port rate. The three standards use their own way to
work out the port rate, based on which each standard calculates the port path cost by a
certain algorithm.
By default, the legacy standard is applied for the switch S8500.
Example
# Set the DOT1D-1998 as the path cost calculation standard on the STP port.
<Quidway>system-view
System View: return to User View with Ctrl+Z.
[Quidway] stp pathcost-standard dot1d-1998

1.1.32 stp point-to-point

Syntax
stp point-to-point { force-true | force-false | auto }
undo stp point-to-point
View
Ethernet port view
Parameter
force-true: Indicates the Ethernet port connected to a point-to-point link.
force-false: Indicates the Ethernet port not connected to a point-to-point link.
auto: Configures to automatically check if the link to the Ethernet port is a point-to-point
link.
Huawei Technologies Proprietary
1-33
Chapter 1 MSTP Configuration Commands