Lock Port - Huawei Quidway S8500 Series Command Manual

Command Manual – Integrated Management
Quidway S8500 Series Routing Switches
port-list: Port list.
both: Specifies to perform flow control.
none: Specifies not to perform flow control.
Description
Use the flow port command to specify whether or not an Ethernet switch performs flow
control when the Ethernet switch sends or receives data through specified ports.
To avoid congestion and packets being dropped, flow control is necessary if the flow
that passes a port is relatively large.
Example
# Specify to perform flow control on port 3 of the Ethernet switch with a position
parameter of 3/1/3-/.
[Quidway-lanswitch3/1/3-/] flow port 3 both
Waiting.....
operating LANSWITCH[3/1/3-/]'s ports successfully!

1.3.6 Lock port

Syntax
lock port port-list
View
Lanswitch view
Parameter
port-list: The port list that requires configuring.
Description
Use the lock port command to disable address learning on the port of the switch.
Example
# Disable address learning on port 1 of the Ethernet switch with the position parameter
of "8/1/1-/"
[Quidway-lanswitch8/1/1-/] lock port 1
Waiting.....
==================Result of Lock port=============
No.
1
============================Notes===============================
Result Val:0-operation success,1-not insert port module,2-port is out of range
Result Port
0 1
Huawei Technologies Proprietary
1-31
Chapter 1 HGMP V1 Configuration Commands
LockState
Lock