Optional) Configuring The Cluster Id For A Route Reflector - Huawei S6700 Series Configuration Manual

Hide thumbs Also See for S6700 Series:

Table of Contents

S6700 Series Ethernet Switches

Configuration Guide - IP Routing

The system view is displayed.

bgp as-number

The BGP view is displayed.

ipv4-family unicast

The IPv4 unicast address family view is displayed.

undo reflect between-clients

Route reflection is disabled between clients.

If the clients of an RR have established full-mesh connections with each other, the undo reflect

between-clients command can be used to disable route reflection between clients in order to

reduce the link cost. By default, route reflection is enabled between the clients of an RR.

This command can only be configured on the RR.

7.9.4 (Optional) Configuring the Cluster ID for a Route Reflector

If several RRs are deployed in a cluster, assigning the same cluster ID to them can prevent route

A backup RR is usually deployed in an AS to prevent a fault on an RR from causing the clients

and non-clients unable to receive routing information. This backup RR improves network

reliability.

Clients 1, 2, and 3 are their clients. An IBGP peer relationship is set up between RR1 and RR2

so that each RR is the other RR's non-client.

Figure 7-1 RR cluster

Issue 01 (2012-03-15)

7-1, RR1 and RR2 are configured as backups for each other in AS 65000.

Huawei Proprietary and Confidential

7 BGP Configuration