Stp Interface Instance Cost - Huawei Quidway S8500 Series Command Manual

Command Manual – STP
Quidway S8500 Series Routing Switches
When MSTP is disabled, the corresponding port stays in forwarding state and does not
take part in any MSTI calculation.
Caution:
If you disable MSTP on a port, a loop may be generated.
Related command: stp mode, stp.
Example
# Enable MSTP on Ethernet 2/1/1 in system view.
<Quidway>system-view
System View: return to User View with Ctrl+Z
[Quidway] stp interface Ethernet 2/1/1

1.1.18 stp interface instance cost

Syntax
stp interface interface-list [ instance instance-id ] cost cost
undo stp interface interface-list [ instance instance-id ] cost
View
System view
Parameter
interface-list: Ethernet port list, containing multiple Ethernet ports and expressed as
interface-list
interface-number ] }&<1-10>. For detail descriptions of interface-type and
interface-number parameters, refer to the corresponding descriptions in Port
Command Manual. &<1-10> means that the preceding parameters can be entered up
to 10 times.
instance-id: Specifies the spanning tree instance ID, ranging from 0 to 48. The instance
0 represents CIST.
cost: Port path cost. Its range depends on the selected standard of path cost.
Description
Use the stp interface cost command to configure the path cost of the specified port on
the specified MSTI in system view.
= { interface-type
Huawei Technologies Proprietary
1-19
Chapter 1 MSTP Configuration Commands
enable
interface-number [ to interface-type