Configuring The Lsr Id; Enabling Mpls - Huawei Quidway S9300 series Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - MPLS
No.
5
6

2.3.2 Configuring the LSR ID

Before enabling MPLS, you must configure LSR ID.
Context
When configuring an LSR ID, note the following:
l
l
l
l
Do as follows on each LSR in an MPLS domain:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
mpls lsr-id lsr-id
The LSR ID of the local node is configured.
----End

2.3.3 Enabling MPLS

MPLS LDP can be enabled only after MPLS is enabled.
Context
Do as follows on each LSR in an MPLS domain:
Issue 04 (2011-12-26)
Data
l (Optional) Value of the Hello Hold timer
l (Optional) Value of the Hello send timer
l (Optional) Value of the Keepalive Hold timer
l (Optional) Value of the Keepalive send timer
l (Optional) Value of the Exponential backoff timer
l (Optional) Peer IP address of MD5 authentication
l (Optional) Password of MD5 authentication
The LSR ID must be configured before other MPLS commands are run.
The LSR ID does not have a default value, and must be configured manually.
It is recommended to use the address of the loopback interface of the LSR as the LSR ID.
To modify the configured LSR ID, you must run the undo mpls command in the system
view to delete all the MPLS configurations.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 MPLS LDP Configuration
39