Huawei Quidway S8500 Series Command Manual page 1116

Command Manual – System Management
Quidway S8500 Series Routing Switches
[ authentication | coldstart | linkdown | linkup | warmstart ]* | system | vrrp
[ authfailure | newmaster ] ]
View
System view
Parameter
standard [ authentication ] [ coldstart ] [ linkdown ] [ linkup ]: Enables the sending
of standard Trap messages.
authentication: Enables the sending of SNMP authentication Trap messages.
coldstart: Enables the sending of SNMP cold start Trap messages.
linkdown: Enables the sending of SNMP link down Trap messages.
linkup: Enables the sending of SNMP link up Trap messages.
warmstart: Enables the sending of SNMP hot start Trap messages.
bgp [ backwardtransition ] [ established ] : Enables the sending of BGP Trap
messages.
configuration: Enables the sending of configuration management Trap messages.
flash: Enables the sending of FLASH Trap messages.
System: Enables the sending of system management MIB Trap messages.
vrrp [ authfailure | newmaster ]: Enables the sending of VRRP Trap messages.
ldp: Enables the sending of LDP Trap messages.
lsp: Enables the sending of LSP Trap messages.
Description
Use the snmp-agent trap enable command to enable the sending of Trap messages.
Use the undo snmp-agent trap enable command to disable the sending of Trap
messages.
By default, Trap message sending is disabled.
The snmp-agent trap enable command and snmp-agent target-host command
should be used at the same time. The snmp-agent target-host command specifies
which hosts can receive Trap message. However, to send Trap message, at least one
the snmp-agent target-host command should be configured.
Example
# Enable to send the trap packet of SNMP authentication failure to 10.1.1.1. The
community name is public.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
Huawei Technologies Proprietary
5-17
Chapter 5 SNMP Configuration Commands