Mpls Ldp Reset-Session; Mpls Ldp Timer - Huawei Quidway S8500 Series Command Manual

Command Manual – MPLS
Quidway S8500 Series Routing Switches
[Quidway-mpls-remote22]
# Delete a Remote-peer.
[Quidway-mpls-remote22] undo mpls ldp remote-peer 22
[Quidway]

1.2.16 mpls ldp reset-session

Syntax
mpls ldp reset-session peer-address
View
VLAN interface view
Parameter
peer-address: Corresponding remote LDP Peer address (in IP address format).
Description
Use the mpls ldp reset-session command to reset a specified session on an
interface.
After LDP is configured on an interface and LDP session is created, this command can
be used to reset a specific session on the interface. You only need to specify the
address of the peer corresponding to the session to be reset.
Related command: mpls ldp and mpls ldp enable.
Example
# Reset a specified session on the VLAN201 interface.
<Quidway>system-view
[Quidway] interface vlan-interface 201
[Quidway-Vlan-interface201] mpls ldp reset-session 10.1.1.1

1.2.17 mpls ldp timer

Syntax
In VLAN interface view:
mpls ldp timer { session-hold session-holdtime | hello hello-holdtime }
undo mpls ldp timer { session-hold | hello }
In remote-peer view:
mpls ldp timer { targeted-session-hold | targeted-hello } { holdtime holdtime |
interval interval }
Chapter 1 MPLS Basic Configuration Commands
Huawei Technologies Proprietary
1-25