Dot1X Max-User - Huawei Quidway S8500 Series Command Manual

Command Manual – Security
Quidway S8500 Series Routing Switches
Example
# Specify to perform port-based authentications.
[Quidway] dot1x port-method portbased
# Enable Guest VLAN on all ports.
[Quidway] dot1x guest-vlan 1

1.1.7 dot1x max-user

Syntax
dot1x max-user user-number [ interface interface-list ]
undo dot1x max-user [ interface interface-list ]
View
System view, Ethernet port view
Parameter
user-number: Specifies the limit to the amount of supplicants on the port, ranging from 1
to 1024.
By default, the maximum user number is 1024. And a switch can accommodate a total
of 2048 users.
interface interface-list: Ethernet interface list expressed in the format interface-list
=interface-type interface-number [ to interface-type interface-number ] &<1-10>.
interface-type means the interface type, interface-number is the interface number.
Refer to command parameters in the "Port" section in the manual for the respective
meanings and value ranges of them. The interface number after the key word to should
be no smaller than the interface number before to. &<1-10> in the command means
that the preceding parameter can be entered up to 10 times.
Description
Use the dot1x max-user command to configure a limit to the amount of supplicants on
the specified interface of 802.1x.
Use the undo dot1x max-user command to restore the default value.
This command is used for setting a limit to the amount of supplicants that 802.1x can
hold on the specified interface. This command has effect on the interface specified by
the parameter interface-list when executed in system view. It has effect on all the
interfaces when no interface is specified. The parameter interface-list cannot be input
when the command is executed in Ethernet interface view and it has effect only on the
current interface.
Related command: display dot1x.
Huawei Technologies Proprietary
1-8
Chapter 1 802.1x Configuration Commands