Stp Interface Loop-Protection - Huawei Quidway S8500 Series Command Manual

Command Manual – STP
Quidway S8500 Series Routing Switches
instance-id: Specifies the spanning tree instance ID, ranging from 0 to 48. The Instance
0 represents CIST.
port priority priority: Specifies the port priority, ranging from 0 to 240 with a step length
of 16, e.g., 0, 16 and 32. By default, the port has a priority of 128 on every MSTI.
Description
Use the stp interface instance port priority command to configure the priority of the
specified port on the specified MSTI in system view.
Use the undo stp interface instance port priority command to restore the default
priority.
You may specify the instance-id parameter as 0 to configure CIST priority of the port.
The port priority has effect on the port role selection for the specified MSTI. A port can
be configured with different priorities on different MSTIs. Thus the traffic from different
VLANs can run over different physical links, thereby implementing the VLAN-based
load-balancing. MSTP will recalculate the port role and transit its state, upon the port
priority changes.
Related command: stp instance port priority.
Example
# Set the priority of Ethernet 2/1/3 on MSTI 2 to 16 in system view.
<Quidway>system-view
System View: return to User View with Ctrl+Z.
[Quidway] stp interface Ethernet 2/1/3 instance 2 port priority 16

1.1.21 stp interface loop-protection

Syntax
stp interface interface-list loop-protection
undo stp interface interface-list loop-protection
View
System view
Parameter
interface-list: Ethernet port list, containing multiple Ethernet ports and expressed as
interface-list
interface-number ] }&<1-10>. For detail descriptions of interface-type and
interface-number parameters, refer to the corresponding descriptions in Port
Command Manual. &<1-10> means that the preceding parameters can be entered up
to 10 times
= { interface-type
Huawei Technologies Proprietary
1-22
Chapter 1 MSTP Configuration Commands
interface-number [ to interface-type