Set Loop-Test - Huawei Quidway S8500 Series Command Manual

Command Manual – Integrated Management
Quidway S8500 Series Routing Switches
View
lanswitch view
Parameter
port-list: List of ports to be aggregated.
sa: Specifies to enable port aggregating only for source addresses.
dasa: Specifies to enable port aggregating for both source and destination addresses.
groupid: Link-aggregation number. This argument can only be 1 at present.
Description
Use the set link-aggregation command to aggregate multiple ports of an Ethernet
switch to an aggregation port, through which a larger capacity can be obtained.
Use the undo set link-aggregation command to remove the configuration.
An S2008B series switch does not support port aggregation; an S2016B series switch
can only has its Ethernet0/15 and Ethernet0/16 port aggregated in the dasa mode; an
S2026B series switch can only has its Ethernet0/23 and Ethernet0/24 port aggregated
in the dasa mode. You can use the query link-aggregation command to verify the set
link-aggregation command.
Related command: query link-aggregation.
Example
# Set the ports 15 and 16 of the Ethernet switch with a position parameter of 3/1/3-/ as
an aggregation port.
[Quidway-lanswitch3/1/3-/] set link-aggregation 15-16 sa 1

1.3.30 set loop-test

Syntax
set loop-test { internal | external } port-list
View
lanswitch view
Parameter
internal | external: Specifies the way to perform loopback test. The internal and
external keywords stand for internal loopback test and external loopback test
respectively.
port-list: List of ports the specified loopback test method applies to.
Chapter 1 HGMP V1 Configuration Commands
Huawei Technologies Proprietary
1-52