Tracert - Huawei Quidway S8500 Series Command Manual

Command Manual – System Management
Quidway S8500 Series Routing Switches
Perform ping command to troubleshoot the network connection and line quality. The
output information includes:
Responses to each of the ECHO-REQUEST messages. If the response message
is not received until timeout, output "Request time out". Or display response
message bytes, packet sequence number, TTL and response time.
The final statistics, including number of sent packets, number of response packets
received, percentage of non-response packets and minimal/maximum/average
value of response time.
If the network transmission rate is too low, you can increase the response message
timeout.
Related command: tracert.
Example
# Check whether the host 202.38.160.244 is reachable.
<Quidway> ping 202.38.160.244
ping 202.38.160.244 : 56 data bytes
Reply from 202.38.160.244 : bytes=56 sequence=1 ttl=255 time = 1ms
Reply from 202.38.160.244 : bytes=56 sequence=2 ttl=255 time = 2ms
Reply from 202.38.160.244 : bytes=56 sequence=3 ttl=255 time = 1ms
Reply from 202.38.160.244 : bytes=56 sequence=4 ttl=255 time = 3ms
Reply from 202.38.160.244 : bytes=56 sequence=5 ttl=255 time = 2ms
--202.38.160.244 ping statistics--
5 packets transmitted
5 packets received
0% packet loss
round-trip min/avg/max = 1/2/3 ms

4.5.2 tracert

Syntax
tracert [ -a source-IP | -f first-TTL | -m max-TTL | -p port | -q num-packet |
-vpn-instance vpn-instance-name | -w timeout ] string
View
Any view
Parameter
-a source-IP: Configures the source IP address used by tracert command;
-f: Configures to verify the -f switch, first-TTL specifies an initial TTL, ranging from 0 to
the maximum TTL.first-TTL defaults to 1;
Huawei Technologies Proprietary
4-31
Chapter 4 System Maintenance Commands