Huawei Quidway S8500 Series Command Manual page 340

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches
Parameter
process-id: Process ID of OSPF. The command is applied to all current OSPF
processes if you do not specify a process ID.
interface-type interface-number: Specifies an interface.
Description
Use the display ospf interface command to view the OSPF interface information.
Example
# Display the OSPF interface information of Vlan-interface1.
<Quidway> display ospf interface vlan-interface 1
OSPF Process 1 with Router ID 1.1.1.1
Interfaces
Interface: 10.110.10.2 (Vlan-interface1)
Cost: 1 State: BackupDR
Priority: 1
Designated Router: 10.110.10.1
Backup Designated Router: 10.110.10.2
Timers: Hello 10, Dead 40, Poll 0, Retransmit 5, Transmit Delay 1
Table 3-6 Description of the fields of the display ospf interface command
Cost
State
Type
Priority
Designated Router
Backup Designated Router
Timers
Transmit Delay
Type: Broadcast
Field
Cost of the interface
State of the interface state machine
Network type of OSPF on the interface
Priority of the interface for DR election in its network
DR on the network in which the interface resides
BDR on the network in which the interface resides
OSPF timers, defining as follows:
Hello
Dead
Poll
Retransmit
Delay time of transmitting LSA
Huawei Technologies Proprietary
3-20
Chapter 3 OSPF Configuration Commands
Description
Interval of Hello packet
Interval of dead neighbors
Interval of poll
Interval of retransmitting LSA